The car stickers. More difficult than the sticker on the label and glass. Because it is a rounded surface that is not smooth. So I have a job that will require a sticker. Car stickers can stick to.
The first step we need the following equipment
one. A rolling frog stickers or rubber
two. Lubrication at sticker (water, shampoo, soap, water)
three. A hair dryer, lighter
four. Scale
Five. Cutter
six. Clear tape
seven. (water injection)
Eight. Lighter
After measuring the width X length. The concave curve of the car. This technique will be successful. Mainly depends on the vehicle. Which to measure the curve of your car and make accurate guesses about. To design off the computer. You can use programs such as graphic design, Photoshop, Ilustrator, 3D Animation, etc.
Then the order came to cut the sticker placed on the vehicle. By peeling back the sticker paper off about half of the alphabet (consciousness. Adhesive letters) If the sticker is not an Inkjet Printer to cut water use. Sprayed on sticker to be able to move the sticker and no air bubbles when we set the appropriate sticker. Be rolled out with a rolling bubble with bubble if we use a hair dryer. Stickers are a few minutes. And then the mangle again. Suggesting that to do this with a bubble in the air.
Guidelines should be sticker car stickers and expertise to make it. Otherwise, it may cause damage sticker is crooked or not straight.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น