Molding is a creative art that required materials are soft and sticky. The materials must be able to form the agglomerate into islands or bars and balance throughout the mold. And must be durable and not easy to break the mold and finished molding. The material used to fabricate a variety of soils, such as clay, wax, oil, sawdust mixed with glue. Paper soaked in water until tender, mix flour, glue, etc., but the materials are easy to find and the price is right for the students. Is as follows.
Clay
A material that occurs naturally. There is hardly any local men became known as the clay used to make various products since ancient times. Because clay is a natural fit for the spin to the new shape as needed toughness is softened with water. And solid when dry. Which can lead to mold the clay into the ground, it will need to be prepared. Start by mixing it with the soil to be removed first. If the soil is dry, it must be solid in water to soak and massage. But be careful not to mix the liquid. Clay can be mold forming soil moist and soft.
Clay or wax
The materials used on clay or wax sculpture. No need to be prepared in advance. Because these materials have been mixed and well prepared. If clay or wax, in too hard. Was exposed to the sun or a little massage, it's just soft.
Equipment used for molding
Basically, there are two aspects
A steel or brass wire
It is a loop round or rounded at the end of a wooden handle and 2 above, there are many types of tools used for forming a chamfer cut and finishing details on certain kinds of steel wire or brass wire on the end. not just one side. The other one is a flat wooden beads are cut off at 45 degrees or 30 degrees wide.
The handle is made of wood
There are many styles and sizes. This is one end of a wooden flat cross section of about 45 degrees or 90 degrees on the other side is the smaller. Are rounded. This type of cutting tool used to cut a smooth surface. Or cause the surface. And other decorative details.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น